EZ-ON® Series Respirators
Note: Also see instructions on bag or box of specific respirator to be used.
• Review all instructions and warnings.
• Demonstrate all fit instructions on box or bag.
• When changing from any model/ size to another respirator, you must fit test.
1. Hold respirator in hand with molded nose contour (narrow end) at finger tips, allowing head harness to fall below hand. | |
2. Place respirator under chin with molded nose contour (narrow end) up. Cushion must be uncreased inside respirator. Pull head harness to top of head so it rests at the crown. | |
3. Adjust tension by pulling on strap within the head harness to provide a tight and comfortable seal. | |
4. Each time before entering a contaminated area, perform a user seal check. Cover front of respirator by cupping both hands. INHALE SHARPLY. A negative pressure should be felt inside respirator. If any leakage is detected at respirator edges, adjust strap by pulling back (on head harness) and/or reposition respirator. Repeat until sealed properly, otherwise see your supervisor. Entry into a contaminated area with an improper fit may result in sickness or death. |
By pressing “Mark Complete,” you acknowledge that you have read and understood the warnings.